E-flite Nieuport 17 250 ARF - Manual (Page 19)

19 E-flite Nieuport 17 Slow Flyer Assembly Manual
 5. Next, the rigging will go up and to the rear hole
in the outer strut as shown.
 6. The rigging will now go through the rear tube in
the fuselage. Note that the rigging in this step must
be behind the rigging headed upward (Step 3).
 7. After exiting the tube, route the rigging up and
to the rear hole in the outer cabane strut as shown.
 8. To complete the first stage of rigging, route it
down and forward through the hole the rigging
originally started at. Leave the end of the rigging
loose at this time and do not tie it to the strut.
 9. The second stage of rigging is similar to the first.
Start by inserting the rigging thread through the
rear hole in the outer strut.
 10. The rigging now heads to the cabane strut to
go through the rear holes in the strut. This line will
be in between the current rigging lines.