E-flite Nieuport 17 250 ARF - Manual (Page 5)

5 E-flite Nieuport 17 Slow Flyer Assembly Manual
 8. Use a pin drill and 1/16-inch (1.5mm) drill bit
to enlarge the outermost hole in the servo arm.
 9. Insert the micro pushrod connector into the servo
arm from the bottom of the horn as shown.
 10. Use a micro pushrod connector backplate to
secure the pushrod connector to the servo arm.
Use pliers to fully push the backplate tight on the
connector.
 11. Repeat Steps 7 through 10 so two servo arms
have been prepared for your servos.
 12. Install the servo arm on the elevator servo. The
arm will be parallel to the center line of the servo
as shown.
 13. Install the servo arm on the rudder servo. The
arm on the rudder servo is installed one spline off
from center so it will not interfere with the fuselage
during operation.
 14. Slide the pushrod wires through the pushrod
connectors at this time.