E-flite Nieuport 17 250 ARF - Manual (Page 13)

13 E-flite Nieuport 17 Slow Flyer Assembly Manual
 2. Use a hobby knife and #11 blade to remove the
material from between each cylinder of the dummy
motor.
 3. Locate the 6mm x 42mm carbon tube. Follow
the instructions included with the motor to glue
(using RTV silicone) the motor to the motor tube. Be
careful not to get glue inside the motor bearing.
 4. Use medium grit sandpaper to roughen the
outside of the carbon tube so the CA used to glue it
in the fuselage has a surface to attach to.
 5. Mount the speed control using two-sided tape
to the front of the fuselage as shown below. Route
the servo lead back to the receiver and plug it into
the throttle port of the receiver. Use a tie wrap (not
included) to keep the wires from interfering with the
operation of the motor.
Leave the tie-wrap loose so the wires from the speed
control can be moved when installing the motor.
 6. Connect the wires from the motor to the
appropriate wires of the speed control.