E-flite Ascent 450 Brushless PNP - Manual (Page 8)

8 E-flite Ascent PNP Assembly Manual
 4. The wing will fit tight against the fuselage when
installed.
 5. Use two 4-40 x 1/2-inch socket head screws and two
#4 washers to secure the wing to the fuselage. Use a
3/32-inch ball driver to tighten the screws.
Stabilizer/Elevator Installation
Required Parts
Fuselage w/wing assembly Stabilizer
Required Tools and Adhesives
Ruler Felt-tipped pen
Sandpaper Painter's tape
6-minute epoxy Mixing stick
Paper towel Mixing cup
Rubbing alcohol
Hobby knife w/new #11 blade
 1. Locate the horizontal stabilizer. Use a ruler to
determine the center of the stabilizer. Use a felt-tipped
pen to mark the center of the stabilizer.