E-flite Ascent 450 Brushless PNP - Manual (Page 10)

10 E-flite Ascent PNP Assembly Manual
 5. Use a felt-tipped pen to transfer the outline of the
fuselage onto the top of the stabilizer.
 6. Remove the stabilizer from the fuselage. Use a hobby
knife with a new #11 blade to remove the covering from
inside the lines drawn in the previous step.
Important: Use light pressure when cutting the covering
to prevent cutting into the stabilizer. Cutting too deep will
weaken the stabilizer and could cause it to fail in flight.
 7. Reposition the stabilizer and connect the bend from the
elevator pushrod to the elevator control horn. The wire
will enter the horn from the side closest to the fuselage.