E-flite Ascent 450 Brushless PNP - Manual (Page 11)

11 E-flite Ascent PNP Assembly Manual
 8. Step back and view the airframe from roughly 8-10
feet (2-3 meters) to check the alignment of the stabilizer
to the wing. If they are not parallel to each other, lightly
sand the fuselage where the stabilizer mounts to correct
the alignment.
 9. Use 6-minute epoxy to glue the stabilizer to the
fuselage. Use painter's tape to keep the stabilizer tight
against the fuselage until the epoxy fully cures. You may
use rubbing alcohol and paper towels to clean up any
epoxy that has squeezed out during assembly.
Fin/Rudder Installation
Required Parts
Fuselage Fin/rudder
Skid
Required Tools and Adhesives
Felt-tipped pen 6-minute epoxy
Painter's tape Square
Mixing cup Mixing stick
Hobby knife Medium CA
Sandpaper Rubbing alcohol
Paper towels
 1. Check the fit of the fin to the fuselage. It should slide
into the fuselage so the hinge line of the fin/rudder
aligned with the hinge line from the stabilizer/elevator.