E-flite Mini Funtana 3D EP ARF - Manual (Page 4)

4
Optional Parts
11x4.7 Slow Flyer Propeller (2) EFLP1147
11x7 Slow Flyer Propeller (2) EFLP1170
12x3.8 Slow Flyer Propeller (2) EFLP1238
Celectra™ 1- to 3-cell LiPo Charger EFLC3005
Spur Gear, 66T w/Shaft EFLM222
Pinion Gear, 10T (0.4 module) EFLM207
Before Starting Assembly
Before beginning the assembly of your Mini Funtana
3D, remove each part from its bag for inspection.
Closely inspect the fuselage, wing panels, rudder
and stabilizer for damage. If you find any damaged
or missing parts, contact the place of purchase.
Using the Manual
This manual is divided into sections to help make
assembly easier to understand, and to provide
breaks between each major section.
Remember to take your time and follow
the directions.
Warning
An RC aircraft is not a toy! If misused, it can cause
serious bodily harm and damage to property. Fly
only in open areas, preferably at AMA (Academy of
Model Aeronautics) approved flying sites, following
all instructions included with your radio.
Important Information About Motor
Selection
We are recommending either the E-flite Park 400
Brushless Motor with 4200Kv (EFLM1100) or the
version with 3700Kv (EFLM1105). The 3700Kv
motor provides plenty of power for sport and
entry level 3D pilots with the ability to hover and
climb vertically using the stock 6.6:1 gearbox and 12
x 6 propeller. This motor will draw less current and
provide longer flight duration. The 4200Kv
motor should only be used by experienced pilots
who manage throttle appropriately. This motor will
provide even better vertical performance at the
expense of flight duration due to the increased
current draw. It is extremely important to monitor
gearbox wear and motor temperature when using
the 4200Kv motor. Lack of proper throttle
management using this motor may result in damage
to the motor, gearbox, esc, and battery.