E-flite Mini Funtana 3D EP ARF - Manual (Page 33)

33
 1. Trim the 75mm x 20mm x 2mm light ply to fit
in position between the fuselage longerons. You
will need to trim the length once the Center of
Gravity has been determined. Check to make
sure all servo wires and ESC wires can reach
the location of the receiver before mounting the
light ply receiver tray. Once the everything has
been checked, use thin CA to glue the ply into
position. Cut a piece of the hook and loop tape
to the size of the receiver. Install the receiver
using the hook and loop. Plug in the rudder and
elevator servos. Route the receiver antenna to
the rear of the plane.
Note : Do not cut the receiver antenna, as this will
greatly reduce the range of the radio system.
Hint : Position the receiver so the ailerons can be
plugged in easily.
 2. Install the speed control using hook and loop
material. Attach the ESC to the side of the
fuselage to provide room for the motor battery.