E-flite Carbon-Z Yak 54 PNP - Manual (Page 8)

EN
Installing Wings
1. Put the wing tube in the round hole in the wing
slot of the fuselage.
2. Put left wing on the wing tube.
3. Move the wing on the tube into the slot in the
fuselage while putting the aileron control
connector in the fuselage.
4. Secure left wing to fuselage using screws.
5. Install the right wing using the steps above.
6. Attach the 2 aileron connectors to the aileron
Y-harness in the fuselage.
Note: There is no difference between the 2 con-
nections on the Y-harness. Left and right servo
lead connectors do not have to be connected to a
particular side of the Y-harness.
If using flaperon/dual aileron transmitter
programming, you can remove the Y-harness. The
aileron leads will connect to AILE and AUX1 when
using flaperon/dual aileron.
Installing Rudder
1. Attach the rudder to the hinge rod. Put the screw
in the bottom of the hinge rod.
NOTICE: Do not tighten the screw too much. The
rudder will not move easily if the screw is tightened
too much.
2. Put the rudder linkage clevis in the hole on the
control horn.
8