beautypg.com

Removing propeller adapter, propeller and spinner, Motor and esc removal – E-flite Carbon-Z Yak 54 PNP User Manual

Page 12

background image

EN

Removing Propeller Adapter,

Propeller and Spinner

Note: The information on this page is for

maintenance of the Yak 54. Spinner, propeller and

propeller adapter damage can result from

aircraft crashes.

CAUTION: DO NOT handle propeller parts while

the flight battery is connected to the ESC. Personal

injury could result.
1. Remove the screw in the spinner.

2. Remove the spinner cone.
3. Use an adjustable wrench to loosen and remove

the propeller nut.

4. Remove the propeller from the prop adapter collet.

5. Remove the spinner backplate from the prop

adapter

collet.

6. Remove the swage plate from the prop

adapter

collet.

7. Remove the prop adapter collet from the

motor

shaft.

Motor and ESC Removal

Note: The information on this page is for

maintenance of the Carbon-Z Yak 54. Damage

to these parts can result from aircraft crashes.

Installation of the motor is in reverse order of the

steps listed below. You must remove the propeller

and spinner from the motor (EFLM7300) before

removing the motor from the aircraft.

CAUTION: DO NOT handle the motor or ESC

while the flight battery is connected to the ESC.

Personal injury could result.
1. Remove the battery hatch from the fuselage.
2. Disconnect the 3 motor wires located on the

bottom of the fuselage near the ESC.

3. Remove the 4 outermost screws on the “X”

mount, and slide the motor out of the nose.

12