E-flite Apprentice 15e PNP - Manual (Page 9)

9 E-flite Apprentice PNP Assembly Manual
 12. Install the first two rubber bands. They should
cross as shown in the image below.
 13. The next two rubber bands will go directly from
the front to the rear of the fuselage, over the wing.
 14. Install the remaining rubber bands using Steps
9 and 10 as a guide. You will install two across (as
in step 9) and then two in line (as in step 10), and
then two across (as in step 9) and then two in line
(as in step 10), and so on until there are no more
rubber bands.
Battery Installation
Required Parts
Assembled airframe
3200 3S 11.1 V LiPo battery (charged)
 1. Lay the model upside-down and turn the battery
hatch keeper 90 degrees to release the hatch.
 2. Open the hatch from the rear of the fuselage as
shown. The front of the hatch is hinged so it will not
detach from the fuselage and get lost.