E-flite Apprentice 15e PNP - Manual (Page 11)

11 E-flite Apprentice PNP Assembly Manual
 2. Use an adjustable wrench to remove the nut
from the propeller adapter. Set the nut aside so it
does not get lost.
 3. Remove the washer and set it aside with the nut
and spinner cone.
 4. Remove the spinner backplate and set it with the
nut, spinner cone and washer.
 5. Slide the propeller from the propeller adapter.
The installation of the propeller is the reverse of
the previous steps. Make sure the nut is tightened
properly so the propeller does not depart from your
model during flight.
Once the radio system has been checked, the propeller
can then be installed. Refer to the section “Installing
the Propeller” later in this manual for details.