E-flite Apprentice 15e PNP - Manual (Page 7)

7 E-flite Apprentice PNP Assembly Manual
 2. Separate the wing panels. Mix 1/2-ounce
(15mL) of 30-minute epoxy and apply it to the root
of both the left and right wing panels.
 3. Slide the wing panels back together. Use low-
tack tape to keep the panels held tightly together.
Wrapping a piece of tape around the leading and
trailing edge will keep the panels in alignment with
each other. Use a paper towel soaked with rubbing
alcohol to remove any excess epoxy before it cures.
Allow the epoxy to fully cure before proceeding to
the next step.
 4. Locate the front and rear wing covers. The front
cover has a rounded edge, while the rear has a
squared edge.
You may want to practice the next steps before
removing the backing from the adhesive tape
on the wing covers. The adhesive will stick
as soon as it touches the wing surface.
 5. Remove the backing from the adhesive tape on
the front wing cover.