E-flite Apprentice 15e PNP - Manual (Page 16)

16 E-flite Apprentice PNP Assembly Manual
 9. Once the rudder has been trimmed for straight
flight, you can now adjust the steering trim of your
Apprentice. Taxi the aircraft to determine if it turns
left or right when the rudder stick is centered. Do
not change the rudder trim at the transmitter.
If the aircraft turns right, thread the clevis IN at
the rudder servo, which will shorten the steering
linkage. If the aircraft turns left, thread the clevis
OUT at the rudder servo, which will lengthen the
steering linkage. Adjust until the aircraft will taxi in
a straight line without any rudder control inputs.
Aircraft turns right—
Thread clevis IN at rudder servo
Aircraft turns left—
Thread clevis OUT at rudder servo
ChECKING ThE AILERONS (MODE 1 AND 2)
 10. Center the aileron stick. Thread the clevis in or
out on the aileron pushrod until the ailerons are
aligned with the wing as shown.
Centered—No change required
Up—Thread clevis in
to move aileron down
Down—Thread clevis out
to move aileron up
 11. Check the movement of the aileron using the
transmitter. When the elevator/aileron stick (Mode
2 transmitter) or throttle/aileron stick (Mode 1
transmitter) is moved right, the right aileron will
move up and the left aileron will move down.