Watts Fleck 2900 Brass Valve - Manual (Page 8)

Page 8
MODEL 3200 & 3210 TIMER SERIES
Regeneration Cycle Program Setting Procedure - Downflow
(Brine Tank Refill Separate From Rapid Rinse)
How To Set The Regeneration Cycle Program:
The regeneration cycle program on your water conditioner has
been factory preset, however, portions of the cycle or program
may be lengthened or shortened in time to suit local conditions.
3200 & 3210 Series Timers (Figure to Right)
To expose cycle program wheel, grasp timer in upper left-hand
corner and pull, releasing snap retainer and swinging timer to
the right
To change the regeneration cycle program, the program wheel
must be removed. Grasp program wheel and squeeze protruding
lugs toward center, lift program wheel off timer. (Switch arms
may require movement to facilitate removal.)
Return timer to closed position engaging snap retainer in back
plate. Make certain all electrical wires locate above snap
retainer post
Timer Setting Procedure for 3200 & 3210 Timer
How To Change The Length Of The Backwash Time:
The program wheel as shown in the drawing is in the service
position. As you look at the numbered side of the program
wheel, the group of pins starting at zero determines the length
of time your unit will backwash.
FOR EXAMPLE: If there are six pins in this section, the time
of backwash will be 12 min. (2 min. per pin). To change the
length of backwash time, add or remove pins as required. The
number of pins times two equals the backwash time in minutes.
How To Change The Length Of Brine And Rinse Time:
The group of holes between the last pin in the backwash section
and the second group of pins determines the length of time that
your unit will brine and rinse (2 min. per hole.)
To change the length of brine and rinse time, move the rapid
rinse group of pins to give more or fewer holes in the brine and
rinse section. Number of holes times two equals brine and rinse
time in minutes.
How To Change The Length Of Rapid Rinse:
The second group of pins on the program wheel determines the
length of time that your water conditioner will rapid rinse. (2
min. per pin.)
To change the length of rapid rinse time, add or remove pins at
the higher numbered end of this section as required. The
number of pins times two equals the rapid rinse time in
minutes.
How To Change The Length Of Brine Tank Refill Time:
The second group of holes in the program wheel determines the
length of time that your water conditioner will refill the brine
tank (2 min. per hole.)
To change the length of refill time, move the two pins at the end
of the second group of holes as required.
The regeneration cycle is complete when the outer microswitch
is tripped by the two pin set at end of the brine tank refill
section.
The program wheel, however, will continue to rotate until the
inner micro-switch drops into the notch on the program wheel.
BRINE & RINSE
SECTION
(2 MIN. PER HOLE)
PIN STORAGE
BACKWASH
SECTION
(2 MIN. PER PIN)
BRINE TANK
REFILL
SECTION
(2 MIN.
PER HOLE)
PROGRAM
WHEEL FOR
CONTROL OF
REGENERATION
CYCLE
RAPID
RINSE
SECTION
(2 MIN.
PER PIN)