Watts Fleck 2900 Brass Valve - Manual (Page 7)

Page 7
MODEL 2900s
3210 Timer Settings
Typical Programming Procedure
Calculate the gallon capacity of the system, subtract the
necessary reserve requirement and set the gallons available
opposite the small white dot on the program wheel gear. Note,
drawing shows 8,750 gallon setting. The capacity (gallons)
arrow denotes remaining gallons exclusive of fixed reserve.
How To Set The Time Of Day:
Press and hold the red button in to disengage the drive gear.
Turn the large gear until the actual time of day is opposite the
time of day pointer.
Release the red button to again engage the drive gear.
How To Manually Regenerate Your Water Conditioner At
Any Time:
Turn the manual regeneration knob clockwise.
This slight movement of the manual regeneration knob engages
the program wheel and starts the regeneration program.
The black center knob will make one revolution in the
following approximately three hours and stop in the position
shown in the drawing.
Even though it takes three hours for this center knob to
complete one revolution, the regeneration cycle of your unit
might be set for only one half of this time.
In any event, conditioned water may be drawn after rinse water
stops flowing from the water conditioner drain line.
Immediate Regeneration Timers:
These timers do not have a 24 hour gear. Setting the gallons on
the program wheel and manual regeneration procedure are the
same as previous instructions.
NOTE:
To set meter capacity
rotate manual knob one
- 360
° revolution to set
gallonage.
* Immediate regeneration timers do not have 24 hour gear. No time of day can be set.
* 24 HOUR
GEAR
MANUAL
REGENERATION
KNOB
PROGRAM
WHEEL
GALLONS LABEL WHITE DOT
RED TIME
SET BUTTON
SERVICE
POSITION
INDICATOR