Month system maintenance annual maintenance – Watts PWROKCZRO User Manual

Page 7

Order filter by calling Watts at 1-800-224-1299
Item Needed: EDP# 7100109

Includes:

• (1) Carbon Block Filter
This reverse osmosis system contains a replaceable compo-

nent (the RO membrane) which is critical to the efficiency of the

system. Replacement of this reverse osmosis membrane should

be with one of identical specifications as defined by Watts to

assure the same efficiency and contaminant reduction perfor-

mance.
Note: Your RO module is equipped with valved heads which will

automatically turn off the water supply to each filter when the

filter is released, thus you do not need to turn off the incoming

water supply at the Adapt-A-Valve™. The faucet must be off

when filter is replaced.
Step A – Place the towel under the RO module to catch any excess

water that drips out from the filters during the changeover .

Step B – To make the removal of the

filter housings easier, the heads

& housings may be lifted up

to 90 degrees as shown in the

pictures to the right . Starting

with cartridge closest to the

pump . Change only the carbon

block filter, lift the cartridge

up to 90 degrees . Rotate the cartridge a

⁄

turn counter-

clockwise, remove and dispose of used cartridge .

Step C – Make sure to remove the

cap off of the new replace-

ment filter . Insert the new filter

cartridge into the head and

rotate it clockwise

⁄

turn until

it stops . Return cartridge to the

vertical position .

Step D – When finished flush your tank

completely once to remove

any natural carbon fines from

the RO system . Check over

the next 24 hours to ensure no

leaks are present .

Photographs for reference purposes

only for Kwik-Change™ drinking water

systems . Your system may contain 2, 3,

or 4 filter cartridges .

6-Month System Maintenance

Annual Maintenance

Order filter by calling Watts at 1-800-224-1299
Item Needed: # 7100119

Includes:

• (1) Carbon Block Filters

• (1) Membrane

• (1) Post GAC

Note: Your RO module is equipped with valved heads which will

automatically turn off the water supply to each filter when the

filter is released, thus you do not need to turn off the incoming

water supply at the Adapt-A-Valve™. The faucet must be off

when filters are replaced.
Step A – Place the towel under the RO module to catch any excess

water that drips out from the filters during the changeover .

Step B – Start with Carbon Block Filter

(closest to pump) . Lift the

cartridge to make the removal

of the filter housings easier, the

heads & housings may be lifted

up to 90 degrees as shown

in the pictures to the right .

Starting with the sediment filter,

lift the cartridge up to 90 degrees . Rotate the cartridge

⁄

turn counterclockwise, remove and dispose of used

cartridge .