BenQ PB6240 - Manual (Page 37)

Maintenance 33
Step 1. Turn the power off and disconnect the projector from the wall socket.
Step 2. Turn the projector over. Then loosen the screws and
remove the lamp cover. If the lamp is hot, avoid
burns by waiting for 45 minutes until the lamp has
cooled.
Step 3. Slide the latch to release the lamp as shown in the
picture.
Step 4. Loosen the screw that holds the lamp to the
projector. If the screw is not loosened completely,
they could injure your fingers. It is strongly
recommended that you use a magnetic-head
screwdriver.
Step 5. Lift the handle so that it stands up. Use the handle
to slowly pull the lamp out of the projector.
• Pulling it too quickly may cause the lamp to break and
scatter broken glass in the projector.
• Do not place the lamp in locations where water might
splash on it, children can reach it, or near flammable
materials.
• Do not insert your hands into the projector after the lamp is removed. If you touch the
optical components inside, it could cause color unevenness and distortion of the
projected images.
Step 6. Insert a new lamp. Make sure the handle is fully
locked, move the latch back, and tighten the screw
firmly.
• Loose screw may cause a bad connection, which could
result in malfunction.
• Do not over tighten the screw.
Step 7. Re-install the lamp cover and tighten the screw. Do not turn the power on with the
lamp cover removed.
Step 8. Restart the projector.
Do not turn the power on with the lamp cover removed.