Banner Q45 Series - Manual (Page 5)

Q45XDN
P/N 46655 rev. C 5
™
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
Specifications
Adjustments Multi-turn SENSITIVITY control on top of the sensor (beneath a transparent o-ring sealed cover) allows
precise sensitivity setting (turn clockwise to increase gain); Internal switch must be in Light Operate (L/O)
position, which is the factory setting
Supply Protection Circuitry Protected against reverse polarity, transient voltages, and loss of ground.
(none of these conditions will harm the sensor or interrupt communication on the network)
Response Time 2 milliseconds; Total response time will also include the response time of the network
Indicators On the sensor: Green and Red; visible through the transparent sensor top cover
Green LED lights for dc power ON
Red LED is Banner’s patented Alignment Indicating Device (AID™, U.S. patent #4356393) which lights
whenever the sensor “sees” a light condition and superimposes a pulse rate which is proportional to
the strength of the received light signal (the stronger the signal, the faster the pulse rate)
On the 45DN Bus Card: Green and Red; visible through the transparent sensor top cover
A bi-color LED indicates the status of the network.
Green
Steady Sensor on line, connected to master
Flashing Sensor on line, address + baud rate are ok
Red Steady Critical network fault or duplicate node address detected; wrong baud rate
Flashing Minor or connection time-out fault
Construction Molded PBT polyester thermoplastic polyester housing; molded acrylic lenses; stainless steel hardware. O-ring
sealed transparent polycarbonate top cover.
Environmental Rating IEC IP67; NEMA 6P
Connections Euro-style DeviceNet ™ -compatible quick-disconnect cables
Operating Temperature -25° to +70°C (-13° to +158°F); Maximum relative humidity 95% (non-condensing)
Supply Voltage and Current The sensor is powered by the bus network (11 to 25V dc @60 mA)
Sensor Configuration The following features of the Q45XDN Series Sensors are programmable via the network with a configuration
tool*:
Feature Range
Network Address 0-63 (default = 63)
Baud Rate 125K, 250K, 500K (default = 125K)
Operate Mode* Light Operate or Dark Operate (default = Light Operate)
All Q45XDN models support:
Explicit Message Connection: Required to Set and Get sensor Attributes
Q45XDN1 supports the following connection type:
Bit Strobe Connection: Responds to a master’s request.
Q45XDN2 supports the following connection type:
Change of State Connection (COS): Responds to a slave’s change of state.
I/O Response is with the following 8-bit word of data:
Bit: 0: 0 Output is OFF
1 Output is ON
Bit 1: 0 Alarm output is OFF
1 Alarm output is ON
Bits 2-7 Not Used: Always 0
*NOTES: Configuration may be simplified through use of an Electronic Data Sheet (Banner model EDS
40223).
The Light/Dark Operate switch in the Q45 sensor must be set to the Light Operate position (the
factory setting).