Banner T-GAGE M18T Series Temperature Sensors - Manual (Page 5)

Teaching Limits Using Dynamic TEACH
Dynamic TEACH is a method of setting the sensor’s threshold while the application is active. Dynamic TEACH will sense the high and
low temperature limits of the process and automatically set the threshold at the midpoint between these limits.
Dynamic TEACH Procedure Result
Push Button Remote Line (0.04 sec < T < 0.8 sec)
Programming
Mode
• Push and hold
push button for 2
seconds
No action required • Power LED turns Red
• Output LED turns Yellow
Enter Dynam-
ic TEACH
Process
• "Double-click" the
push button
• Double-pulse the remote line
T T
T
• Sensor begins dynamic learning
process
• Output LED flashes Yellow @ 2 Hz
End Dynamic
TEACH Proc-
ess
• "Single-click" the
push button
• Single-pulse the remote line
T
• Sensor ends data collection; sets
threshold
• Power LED turns Green
• Sensor returns to Run mode
Hot Operate/Cold Operate Select
The sensor can be configured for either Hot Operate or Cold Operate via the remote teach wire (gray). A series of three pulses on the
line will toggle between Hot and Cold Operation.
Procedure Result
Push Button Remote Line (0.04 sec < T <
0.8 sec)
Toggle Between
Hot Operate / Cold
Operate
• Not available via push but-
ton
• Three-pulse the remote
line
T T
T
T
T
• Either Hot Operate or Cold Operate is selec-
ted, depending on previous condition
Push Button Lockout
The push button lockout feature enables or disables the push button to prevent unauthorized adjustment of the program settings.
Procedure Result
Push Button Remote Line (0.04 sec < T < 0.8 sec)
Push But-
ton Lockout
Not available via push but-
ton • Four-pulse the remote line
T T
T T T
T T
• Push button is either enabled or dis-
abled, depending on previous condi-
tion
Installation Notes
Align the sensor toward the object to be detected. Visually align if possible, or use the alignment device accessory listed in Additional
Accessories on page 9.
M18T T-Gage Sensor
P/N 120632 Rev. A www.bannerengineering.com - tel: 763-544-3164 5