Metrohm 850 Professional IC Detector - iDetector - Manual (Page 18)

2.3 Connecting the detector
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
10 ￭￭￭￭￭￭￭￭
2.850.9010 IC Conductivity Detector
2.3 Connecting the detector
Connecting the detector cable and the detector outlet
capillary
CAUTION
The instrument must be switched off when connecting a detector.
1 Connecting the detector
￭ Connect the detector connection cable (3-1) to the detector con-
nection socket Detector 1.
NOTE
Recommendation: In AnCat systems with 2 detectors: anions to
Detector 1, cations to Detector 2.
2 Connecting the detector outlet capillary
￭ Guide the detector outlet capillary (3-2) into a sufficiently large
waste container and fasten it there.
NOTE
The detector outlet capillary must be free of blockages (the mea-
suring cell is tested to 5 MPa = 50 bar backpressure).
NOTE
The detector outlet capillary must not be shortened!
Shortening the detector outlet capillary leads to increased noise!