Metrohm 786 Swing Head - Manual (Page 25)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Installation
786 Swing Head ￭￭￭￭￭￭￭￭ 17
1 2
3
Figure 11 Mounting the robotic arm
Mount the robotic arm as follows:
1 Place the 6.1458.040 titration head insert in the opening of the robotic
arm and screw tight with the supplied screws.
2 Hold the robotic arm in such a way that the opening faces to the right.
While doing so, rotate the robotic arm outwards as far as possible,
i.e. towards the tower - see above. Slip the robotic arm from below
over the guide pins of the drive disc of the Swing Head.
Note
Take care to ensure that you do not twist the drive disc, thus causing
pressure against the drive.
3 Screw the robotic arm to the Swing Head tightly with the screws and
washers provided.