Metrohm 786 Swing Head - Manual (Page 17)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Installation
786 Swing Head ￭￭￭￭￭￭￭￭ 9
Connecting the Swing Head
The connection socket (Mini DIN) for the Swing Head drive is each located
on the rear of the tower next to the stirrer connector.
Figure 3 Connecting Swing Head
Connect the Swing Head as follows:
1 Plug in the cable
￭ Guide the connection cable of the Swing Head through the guide
chain of the tower (see Chapter 3.3.2, page 11).
￭ Plug the Mini DIN plug into the socket 'Swing Head'.
Mounting the Swing Head
1
2
3
4
1 Screw the Swing Head tightly to the holder plate of the guide chain.
2 Clamp the Swing Head between the guide jaws.
3 Screw the Swing Head to the guide jaws with the screws previously
loosened.