Metrohm 824 Easy Sample Changer - Manual (Page 19)

2.4 Attaching and equipping a titration head
824 Easy Sample Changer, Installation
13
When attaching the tubing and cable connections these should be led
from the titration head through the tubing guide in order not to restrict
the range of movement of the lift. Take care that the tubing is long
enough to accommodate the whole range of movement of the lift.
2.4.2 Attaching the splash protector
For safety reasons the 824 Easy Sample Changer should not be oper-
ated unless the splash protector is in its proper position.
Fig. 10 Attaching the splash protector
• On both sides of the tower loosen knurled nuts
26.
• Slip the slot-shaped openings of the splash
protector 13 over the attachment screws and
tighten up knurled nuts 26 again.
• If the knurled nuts 26 are loosened slightly it is
easy to adjust the height of the splash protector
13.
2.4.3 741 Magnetic Stirrer
Fig. 11 Attaching the magnetic stirrer
Apart from the micro-titration head, the
2.824.020 version also includes a 741 Magnetic
Stirrer.
The use of the 741 Magnetic Stirrer is particularly
recommended for Karl Fischer titrations.
The 2.741.0010 Magnetic Stirrer can be attached
to the tower by using the holder (6.2034.020)
and supplied screws as shown in the drawing
alongside.
26
13