Metrohm 874 USB Oven Sample Processor - Manual (Page 37)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Installation
874 Oven Sample Processor ￭￭￭￭￭￭￭￭ 29
2 Establishing cable connections
￭ Connect all peripheral devices to the instrument (see Chapter
3.15, page 30).
￭ Connect the 874 Oven Sample Processor to the mains supply if
you have not already done this.
￭ Connect the instrument to your computer through a USB connec-
tor (Type A) (see Instructions for Use for your computer). The
6.2151.000 cable is used for this purpose.
6.2151.000
USB 2
USB 1
Contr.
MSB 2
Figure 18 Connecting the computer
For Windows 2000: The instrument is recognized and the driver is
installed automatically.
For Windows XP: The instrument is recognized and the installation
assistant for the driver is started automatically. Select the option
"Install software automatically" and click on [Continue]. Exit the
assistant with [Finish].
For Windows Vista: The instrument is recognized and the installa-
tion assistant for the driver is started automatically. Select the option
"Find and install driver software". Agree to all subsequent requests.
The installation assistant will be exited automatically.
Note
The plug on the instrument end of the 6.2151.000 controller cable is
protected with an anti-pull device to prevent the cable from being
pulled out accidentally. If you wish to pull out the plug, then you must
first retract the outer plug sleeve marked with arrows.
Registering and configuring the instrument in the PC soft-
ware
The instrument must be registered in the configuration of your PC soft-
ware. Once that has been done, you can then configure it according to
your requirements. Proceed as follows: