Metrohm 902 Titrando - Manual (Page 20)

3.2 Connecting a controller
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
12 ￭￭￭￭￭￭￭￭
902 Titrando
6.2151.000
Figure 5 Connecting the computer
The instrument is recognized. Depending on the version of the Win-
dows operating system used, the driver installation proceeds differ-
ently afterwards. Either the necessary driver software is installed
automatically or an installation wizard is started.
3 Follow the instructions of the installation wizard.
The "On" LED on the 902 Titrando lights up when the driver installa-
tion has been completed and the instrument is ready for operation.
If problems should occur during installation, contact your company's IT
support team.
NOTE
The plug on the instrument end of the 6.2151.000 controller cable is
protected against accidental disconnection by means of a pull-out pro-
tection feature. If you wish to pull out the plug, you will first need to
pull back the outer plug sleeve marked with arrows.
Registering and configuring the instrument in the PC soft-
ware
The instrument must be registered in the configuration of your PC soft-
ware. Once that has been done, you can then configure it according to
your requirements. Proceed as follows: