DJI Phantom 2 User Manual User Manual

Page 34

1. Turn off the remote control and find the Micro-USB port on the bottom of it.

2. Start up the PC, power on the remote control, and then connect the remote control to the PC with a

Micro-USB cable. DO NOT disconnect until the configuration is finished.

3. Run the PHANTOM RC Assistant and wait for the remote control to connect to the Assistant. Observe the

indicators

on the bottom left of the screen. When connected successfully, the connection indicator is

and communication indicator is blinking .

4. Finish configuration in the [Main] page.

5. Finish upgrade in the [Info] page if necessary.

DT7

调参软件

Main Page of the 2.4GHz Remote Control

Language swap

Main page

Connection indicator

Communication indicator

Firmware upgrade
Account, software
version

*This image is for
reference only. Please
refer to the actual
user interface.

This manual is related to the following products: