Using, Intel® active management technology (intel® amt), Below – ClearCube A6106D Blade User Manual
Page 9: Using intel, Active management technology (intel, Amt)
Page 9 of 10
P/N G0200152 Rev B, 1.1.12.01.2014
ClearCube Technology, Inc. 3700 W Parmer Lane Austin, TX 78727 (512) 652-3500 www.clearcube.com
Using Intel
®
Active Management Technology (Intel
®
AMT)
About Intel
AMT
A6106D blades support Intel AMT Release 8.0. Intel AMT enables administrators to manage blades
remotely, including when blades are powered off.
Requirements
Intel AMT requires the installation of a third-party management console. Install management console
software on the system you will use to manage AMT clients.
There are many management console products, such as VNC
®
Viewer Plus, Radmin
®
, and
Spiceworks
®
. Be sure to choose a console that supports your management objectives.
Supported and
unsupported
features
A6106D blades support all Intel AMT Release 8.0 features except for KVM over IP once the
operating system has started. All other features are supported.
A3100 chassis
support
The A3100 chassis supports Intel AMT through the primary Ethernet port only. See
for more information.
Accessing Intel
ME BIOS
extension
Intel AMT settings are located in an Intel Management Engine BIOS extension. To access the BIOS
extension:
Step
Action
1
Remove the blade from the chassis and configure as shown in “
video for configuration and imaging
2
Power on or restart the blade.
3
Press CTRL+P during startup (this is the same time you would press, for example,
F2 to display the BIOS setup utility).
4
Use the credentials listed in “
Default configuration and login credentials
log in and make any changes appropriate for your environment.
5
If you management console requires a user name to perform Intel AMT commands,
use the user name listed below.
Default
configuration
and login
credentials
The list below shows default Intel AMT configuration on A6106D blades:
Intel AMT is enabled
Default Intel AMT password is admin.
NOTE:
Change this password immediately after first login.
Default Intel AMT user is admin (for use with management console)
For more
information
See Intel
®
Active Management Technology (Intel
®
AMT) Start Here Guide, available at
www.intel.com
.