Calculated Industries 6215 User Manual
Page 24
User’s Guide — 23
The settings should read:
Bits per second
9600
Data bits
8
Parity
None
Stop bits
1
Flow control
None
7.
After changing the settings click OK.
8.
Once you find a communications port that is active (does not
have an error message and you see a blank screen), you
should turn on your
Scale Master II, roll a measurement, and
press [SET] to send it to HyperTerminal. The value should appear
within the HyperTerminal window.
9.
If your
Scale Master II does not send the value to HyperTerminal,
try a different Communications Port than the one you are
currently using. (See step 10.)
10. Go to File in the upper left part of the window titled, “
SM2 –
HyperTerminal.” Click on, “New Connection.” A message will
come up, “You are currently connected. Are you sure you want
to disconnect now?” Click Yes. After which, another message
will come up, “Do you want to save session SM2?” or “Do you
want to save the connection named SM2?” Click No.
11. Redo steps 2-7 (changing to a new COM port at Step 4) until
you have tried all the COM ports listed under “Connect Using.”
12. If you have no success in sending a value to HyperTerminal on
any of the COM ports, you have a Windows communications
port problem. This must be configured properly by a Windows
expert.
6215UG-E-G 9/2/03 2:38 PM Page 23