Calculated Industries 6215 - Manual (Page 16)

User’s Guide — 15
Sending Areas or Volumes
Sending Areas
1. Open your spreadsheet or application program and click on a
desired cell.
2. Roll the first dimension with your Scale Master II and press
[LENGTH]. This will store the value as length.
NOTE: The SMII will reset to zero after you press Length or Width.
3. Roll the second dimension and press [WIDTH].
4. Press [SQ/CU] [SET]. This will calculate the area from the stored
length and width values and send it to your PC. Note that you must
press the [SQ/CU] key first to find the area, then press [SET] to
send the value to your PC.
Sending Volumes
1. Open your spreadsheet or application program and click on a
desired cell.
2. Roll the first dimension and press [LENGTH].
3. Roll the second dimension and press [WIDTH].
4. To set a height, roll a third dimension and press [RCL] [SET]
[SQ/CU]. The measurement will display and the units of
measurement (i.e., FT-IN) will be flashing.
5. Press [SET] to store as height.
NOTE: Once you set your height in Steps 4 & 5, you do not need to
enter it again unless you want to change it, as the height is semi-
permanently stored.
6. Press [SQ/CU] to calculate the area. Press the [SQ/CU] key again
to find the volume. Press [SET] to send the value to your PC. Press
[SQ/CU] a third time to display the value stored as height.
6215UG-E-G 9/2/03 2:38 PM Page 15