Pc interface commands – Calculated Industries 6215 User Manual

Page 20

Text mode
Original mode

User’s Guide — 19

PC INTERFACE COMMANDS

[SET]

Sends the displayed value to a cell in your PC’s spreadsheet or
estimating program. The numerical value on the main display will be
sent without display legends or annunciators. Also, this value will
only be displayed on your PC in decimal format.

[RCL] [SET]

This will allow you to use the [SET] key as if it were not connected
to the PC.

[RCL] [COUNT] [SET]

Recalls the Count value to the main display, then sends the value to
your PC.

[RESET]

Clears all non-permanent registers.

[RESET] and [SUB] together

Full Reset. Clears all semi-permanent registers.

6215UG-E-G 9/2/03 2:38 PM Page 19