Calculated Industries 4065 v3.0 - Manual (Page 90)

U SER ’ S G UIDE — 89
The Construction Master Pro calculators have Preference Settings
that allow you to customize or set desired dimensional formats and
calculations. The options vary per model.
If you replace your batteries or perform a Full Reset* (press O , hold
down x , and press o ), your calculator will return to the following
settings (in addition to those listed on the previous page):
PREFERENCE OPTIONS
1) Fractional Resolution – *1/16 (displays fractional values to the
nearest 16th of an inch)
–
– 1/32
– 1/64
– 1/2
– 1/4
– 1/8
2) Area Display Format – *Standard (if units entered are the
same—e.g., feet x feet—the answer will
remain in this format (sq. ft), but if units
entered are different —e.g., inches x
feet—area answer will be displayed in
square feet)
– Square Feet (area answers always
displayed in sq. ft, regardless of unit
entry—e.g., inches x inches = sq. ft)
– Square Yards (area answers always
displayed in sq. yards—e.g., feet x feet
= sq. yds)
– Square Meters (area answers always
displayed in sq. meters—e.g., feet x feet
= sq. meters)
Note: To check the current Fractional Resolution, press ® / . Either “Std” (standard
fractional resolution) or “Cnst” (constant) will be displayed, along with the fractional
resolution).
(Cont’d)
APPENDIX B — PREFERENCE SETTINGS
4065UG-E-B 6/9/04 1:50 PM Page 89