Calculated Industries 4065 v3.0 - Manual (Page 26)

U SER ’ S G UIDE — 25
ENTERING DIMENSIONS
Entering Linear Dimensions
When entering feet-inch-fraction values, enter dimensions from
largest to smallest — e.g., feet before inches, and inches before
fractions. Enter fractions by entering the numerator (top), pressing
/ (fraction bar key), and then the denominator (bottom).
Note: If a denominator is not entered, the fractional setting value is used.
Examples of Entering Linear Dimensions:
DIMENSION KEYSTROKES
Clear calculator o
5 Feet 1-1/2 Inch 5 f 1 i 1 / 2
Clear calculator o
5 Yards 5 y
Clear calculator o
17.5 Meters 1 7 • 5 m
Entering Square/Cubic Dimensions
The Construction Master Pro lets you easily enter square and cubic
values. Simply press a dimensional unit key two times to label a
number as a square value, or three times to label a cubic value.
Note: If you pass the desired dimensional format, keep on pressing the dimensional
unit key until the desired result is displayed again.
Enter square and cubic dimensions in the following order:
(1) Enter numerical value (e.g., 1 0 0 ).
(2) Press desired unit key (e.g., f ) to label value as “linear.”
KEYSTROKE DISPLAY
o o 0.
1 0 0 f 100 FEET
(3) Second press of unit key (e.g., f f ) labels value as “square.”
KEYSTROKE DISPLAY
o o 0.
1 0 0 f f 100 SQ FEET
(4) Third press of unit key (e.g., f f f ) labels value as “cubic.”
KEYSTROKE DISPLAY
o o 0.
1 0 0 f f f 100 CU FEET
Note: Feet-Inches format cannot be used to enter square or cubic values.
4065UG-E-B 6/9/04 1:49 PM Page 25