brite-View Air Sync3D BVW-200 User Manual - Manual (Page 4)

3
EN 55024 Information technology
equipment‐‐‐‐
Equipment‐‐‐Immunity
characteristics‐‐‐Limits and methods of
measurement
EN 301 489‐1
Electromagnetic compatibility and Radio
spectrum Matters (ERM); Electro Magnetic
Compatibility (EMC) standard for radio
equipment and services;
Part 1: Common technical requirements
Special Notice
z Never use this product nearby an aircraft
or medical facility. It can cause
interference or undesirable effect on the
operation result.
z Use of this product in the following
locations may result in abnormal video
and audio output (noise, blocked image...
etc,).
¾ Product installed in the walls made
of concrete.
¾ Product is situated near the
refrigerator or metal fitment.
¾ A cluttered room where the
wireless signals may be blocked
z This product has been tested and
manufactured to comply with each
country’s safety rules. However, there is
no guarantee that interference will not
occur in some installation scenario. If the
interference happens, increase the
distance between the transmitter and
receiver.
z BVW‐200 may interfere 5GHz wireless
devices, such as routers or other wireless
devices. Therefore, if you have an
802.11n router, configure it to the 2.4
GHz band rather than the 5GHz band.
z Optimal range between BVW‐200
transmitter and receiver is between 2 and
20 meters within line of sight.
EN 55022 Information technology
equipment‐‐‐‐
Radio disturbance characteristics‐‐‐ Limits
and methods of measurement
EN 61000‐3‐2 Electromagnetic compatibility
(EMC)‐‐‐
Part 3‐2:Limits‐‐‐Limits for harmonic current
emissions (equipment input current up to
and including 16 A per phase)
EN 61000‐3‐3 Electromagnetic compatibility
(EMC)‐‐‐
Part 3:Limits‐‐‐Section 3: Limitation of
voltage changes, voltage fluctuations and
flicker in public low‐voltage supply systems,
for equipment with rated current
≦16 A per
phase and not subject to conditional
connection
DECLARATION OF CONFORMITY
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
EMI (Electro Magnetic Interference) tested.
TRADEMARK INFORMATION
z
HDMI, the HDMI Logo and
High‐Definition Multimedia Interface
are trademarks of HDMI Licensing LLC.
EN 301 489‐17
Electromagnetic compatibility and Radio
spectrum Matters (ERM); Electro magnetic
Compatibility(EMC) standard for radio
equipment;
Part 17: Specific conditions for 2,4 GHz
wideband transmission systems, 5GHz high
performance RLAN equipment and 5,8 GHz
Broadband Transmitting Systems
EN 60065 Audio，video and similar
electronic apparatus—Safety requirements