brite-View Air Sync3D BVW-200 User Manual - Manual (Page 20)

19
4.
Troubleshooting
Problem Solution
The BVW‐200 power
indicator LED doesn't
light up.
• Check if the power plugs of BVW‐200T/BVW‐200R are properly
inserted into a functioning power outlet.
No video is displayed
on your TV screen.
• Verify that the proper cables have been selected and installed
between the BVW‐200T (transmitter) input and your High‐Definition
device output.
• On your TV side (connected to the BVW‐200R), select the HDMI as
input source.
• Verify the status of POWER LED and SOURCE LED indicator of
BVW‐200 as below:
Power LED Flashing in Blue
OSD displayed: (4 levels looping)
* Ensure the transmission range between the transmitter and the
receiver is NOT over 66 feet (LOS‐line of sight) transmission distance.
* Try to move the transmitter closer to the receiver.
POWER LED in Solid Blue + Slow and Flashing SOURCE LED
OSD displayed :
* Ensure your video resolution and frame rate is recognized/ supported
and within the transmission range.
*Connect the source device to your TV to check and modify the video
format compatibility.
*Check if your video resolution with HDMI input from your device is set
among 1080p, 1080i, 720p, 576p, or 480p. Please refer Chapter 5 for
the detail supported Resolution.
POWER LED in Solid Blue STATUS LED Flash Quickly
OSD displayed :