brite-View Air Sync3D BVW-200 User Manual - Manual (Page 18)

17
(7) On Screen Display (OSD) vs. Key button Instruction
X On Active mode, Press the POWER button on the top of Receiver (or transmitter), both receiver
and transmitter enter Standby mode and transmitter’s HDMI out is on.
OSD Displayed: (Display 3secs and then enter Standby mode.)
ON
Y Press the INFO button on the top of Receiver (or transmitter), and Signal Quality, Source,
Channel and resolution will be displayed for user reference.
OSD Displayed: (Press again for exit.)
HDMI1 CH10 1280x1024
= OFF
Z Keep press the INFO. button on the top of Receiver (or transmitter) over 3sec., OSD displayed
current IR frequency on 2
nd
HDTV, while OSD displayed IR freq. period press INFO. Button again
for change IR Blaster frequency, enable to switch IR Blaster frequency 47K to 56K to 36K recurring.
(Note : IR blaster frequency default setting is 47KHz)
Press once for current IR frequency status display. The OSD shows:
HDMI1 CH10 1280x1024
= 38KHz
Press IR key again to switch IR blaster frequency. The OSD shows:
HDMI1 CH10 1280x1024
= 40KHz
NOTE: Only the status of the BVW‐200R (receiver) connected to the HDTV can be displayed on the
OSD. The status of the BVW‐200T (transmitter) HDMI out cannot be displayed.