brite-View Air Sync3D BVW-200 User Manual User Manual

Page 15

Step 4: Boot up the Transmitter and Receiver

(1) After the power cord is plugged into the electrical outlet, the BVW‐200 will be turned on

automatically.

(2)

(3) If it is in Standby mode (Both POWER LED of transmitter and receiver are lit in red), press the

POWER button either transmitter or receiver to turn on the transmitter and the receiver. Same
condition for remote control operation.

Please note, the HDMI out display always on even the transmitter in standby mode.

(4) During the warm‐up, the POWER LED will blink in blue until the signal link between the

BVW‐200T and the BVW‐200R is established. It will take 15 ~ 20 seconds for system boot up
successfully.