Blizzard Lighting EM-Pulse LED Strobe Fixture - Manual (Page 13)

Page 13
EM-Pulse User Manual - Rev. A (c) 2014 Blizzard Lighting, LLC
Additional Features:
Never thought you would ever see so many nifty neato features in a strobe light did you?
Temperature:
IMPORTANT - Brightness will decrease when the LED temperature rises over 55ºC.
If a temperature of +70ºC is reached, the overheat protection sensor will activate,
initiating blackout until a safe temperature is reached. It’s highly recommended
to not use the LEDs at full strobe brightness for longer than a 1 minute
period. You can safely use the fixture as a normal wash in 3/9 pixel modes
which are programmed to achieve a max of 40% strobe brightness.
1.) Press the buttons until you reach Temp.
2.) Push the button.
3.) The display will show the current temperature in Celsius degrees.
Signal Loss Settings:
In the event of DMX signal loss, you can set the fixture to either hold its last
received DMX signal values, or clear them.
1.) Press the buttons until you reach Config.
2.) Push the button.
3.) Using the buttons, navigate to DMX Status, then press the
button.
4.) Use the buttons to select either Value Hold, or Value Clear.
5.) Press the button to confirm.
LCD Display On/Auto Off:
Display mode On will keep the LCD illuminated continually, Auto will shut the display
off after 30 seconds of inactivity.
1.) Press the buttons until you reach Config.
2.) Push the button, and navigate to Display Mode.
3.) Push the button, then select either On or Auto, and press the
button.
Key (Button) Protection Mode:
With Key Lock active, buttons will be unresponsive to any initial button press after
30 seconds of inactivity. Temporary unlock will occur with more than 1 button
press. To disable this feature, activate Key Unlock.
1.) Press the buttons until you reach Config.
2.) Push the button.
3.) Press the buttons until you reach Key Mode, then press
.
4.) Use the buttons to select either Key Lock, or Key Unlock, and
press the button.
Test Mode:
1.) Press the buttons until you reach Test LED.
2.) Push the button.
3.) Now, you can choose to test all of the LEDs at once, or individually test each
of its 9 segments. Use the buttons to navigate, and press the
to confirm.