Blizzard Lighting EM-Pulse LED Strobe Fixture - Manual (Page 12)

Page 12
EM-Pulse User Manual - Rev. A (c) 2014 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
Set the Starting DMX Address:
The default mode for the fixture is DMX, so the first menu item that you can edit is
the starting DMX address.
1.) Press the buttons until you reach Address.
2.) Push the button.
3.) Use the buttons to select a channel from 001-512.
4.) Press the button to confirm.
5.) Press the button to return to the main menu.
Select the DMX Channel Mode:
1.) Press the buttons until you reach Config.
2.) Push the button.
3.) Using the buttons, highlight DMX Mode, then press .
4.) Use the buttons to select 1, 3, 4, 6, 7, 16, or 3/9 pixel modes.
5.) Press , and then press the button until you reach the
Address screen.
Master/Slave Mode:
1.) Disconnect fixture(s) from any DMX signal source.
2.) Set each fixture to matching DMX modes.
3.) Connect all fixtures together via DMX. The first fixture in the DMX chain will be
the master, followed by the slave fixtures.
4.) Connect DMX controller to the master unit for DMX control.
Load Default Settings:
1.) Press the buttons until you reach Load Default.
2.) Push the button.
Auto & Standalone Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable
speeds.
Auto Mode:
1.) Press the buttons until you reach Auto.
2.) Push the button.
3.) Use the buttons to select from Mode 1 to Mode 5.
4.) Press the button to confirm.
Auto Program Speed:
1.) Press the buttons until you reach Speed.
2.) Push the button.
3.) Use the buttons to select from 000-031.
4.) Press the button to confirm.