Bird Technologies BA-310 Series - Manual (Page 15)

5
Chapter 3 Installation
This chapter provides information for on-site requirements,
unpacking, inspection, and preparing the unit for use.
Unpacking and
Inspection
1. Carefully inspect the shipping container for signs of damage. If
damage is noticed, do not unpack the unit. Immediately notify the
shipping carrier and Bird Electronic Corporation.
2. If the container is not damaged, unpack the unit. Save the packing
materials in case the unit should need to be shipped again.
3. Inspect all of the components for visible signs of damage.
Immediately notify the shipping carrier and Bird Electronic
Corporation of equipment damage or missing parts.
Mounting
Place the Blower Assembly in a dry, dust and vibration free environ-
ment. Do not use outdoors or in areas of condensing humidity. Allow
at least 3" (7.6 cm) of clearance above and on all sides of the unit.
Bird Blower Assemblies are equipped for either portable use or fixed
installation. The mounting brackets on the front and rear faces have
four mounting slots arranged in a 4
1 ⁄
2
" x 20 23 ⁄
32
" rectangle (114.3 x
526.3 mm). Use a screw with a 3 ⁄
8
" (9.53 mm) diameter max.
CAUTION
The BA system is designed for operation in a horizontal position
only, with the load’s vent plug up. Do not use in any other manner.