Bird Technologies 8920 Series - Manual (Page 18)

8
Unflanged Coupling
Note: To couple the unflanged connector with an unflanged RF line, use an appropriate coupling kit. Refer
to Figure 6 while following the instructions below:
1. Insert the center bullet and bottom it on the midpoint nibs.
2. Position the outer sleeve, with clamping bands, over the input connector.
3. Set the transmission line snugly against the coupling stops.
4. Position the clamping bands evenly about 3/4” from the ends of the sleeve.
5. Tighten the clamping bands.
Figure 6 Unflanged Coupling
RF COAXIAL
LINE
CLAMPING
BANDS
CONNECTOR
SLEEVE
BULLET LOAD