Bird Technologies 8920 Series - Manual (Page 15)

5
Chapter 3 Installation
This chapter provides information for on-site requirements, unpacking, inspection, and preparing the load for use.
Unpacking and Inspection
1. Carefully inspect shipping container for signs of damage.
2. Do one of the following:
•
If the shipping container is damaged, do not unpack the unit. Immediately notify
the shipping carrier and Bird Electronic Corporation.
•
If the shipping container is not damaged, unpack the unit. Save shipping materi-
als for repackaging.
3. Inspect unit for visual signs of damage.
Note: If there is damage, immediately notify the shipping carrier and Bird Elec-
tronic Corporation.
Mounting
Place the load in a dry, dust and vibration free environment. Do not use outdoors or in areas of condensing humidity.
Allow at least 12" (30 cm) of clearance on all sides of the load.
The load is equipped for either portable use or fixed installation. The mounting brackets on the front and rear faces
have four mounting slots arranged in a 4
1 ⁄
2
" x 14
7 ⁄
32
" rectangle (114.3 x 361.2 mm). Use a screw with a
3 ⁄
8
" (9.53
mm) diameter max.
CAUTION
This load is designed for operation in a horizontal position only, with the vent plug up. Do not use in any other
manner.
WARNING
The vent plug must be used at all times when the unit is operating or cooling. Failure to do so could result in an
explosion or severe burns.