Diagnostic trouble codes, Dtcs) – Bendix Commercial Vehicle Systems TABS-6 ADVANCED SINGLE CHANNEL User Manual
Page 17

17
Diagnostic Trouble Codes
(DTCs)
(continued)
1st
Digit
2nd
Digit
Diagnostic
Code
Description
Possible Causes / Repair Information
J1587
(SID/
FMI)
J1939
(SPN/
FMI)
11
9
TABS‑6
Advanced
Auxiliary
Program Error:
ADL
• Verify that the Auxiliary I/O ECU pin-outs match the ADL parameters
using the Bendix
®
ACom
®
Diagnostic Software (version 6.1 or higher).
• If necessary, contact the BCVS local representative to troubleshoot the
ADL program.
152/12
612/12
11
11
WL Information:
ADL
• Verify that the ADL parameters are correct using the Bendix
®
ACom
®
Diagnostic Software (version 6.1 or higher).
• If necessary, contact the BCVS local representative to troubleshoot the
ADL program.
152/14
612/12
Miscellaneous
12
1
Service
Distance or Date
Exceeded
• Perform scheduled trailer maintenance and/or reset the Service Distance
or Date using the Bendix
®
ACom
®
Diagnostic Software (version 6.1 or
higher).
153/00
612/00
12
2
Trailer Load Out
of Range
• If trailer is equipped with a raise/lower valve, verify it is in the drive
position.
• Verify that the ECU parameters for the empty and fully loaded trailer
conditions are correct using the Bendix
®
ACom
®
Diagnostic Software
(version 6.1 or higher).
• If necessary, contact the BCVS local representative to troubleshoot the
trailer’s loading condition.
069/13 1059/13
12
3
Brake Pads
Worn
• Manually check the condition of the pads on each brake to determine if
any require replacement.
• If no pads require replacement, check the wear sensors and cables for
damage or defects.
070/01 1060/01
12
8
Trailer
Information
Module Missing
• Trailer Information Module and/or harness damaged or not present.
254/11
0/11
Mechanical Load Sensor
13
4
Load Sensor
Error
• (Spring Suspension Systems) Inspect the linkage: Check that the
linkage is attached to the axle, inspect for damage to the linkage
components, loose connectors and mis‑installation.
• If the diagnostic code persists, contact your local Bendix representative
before replacing the TABS‑6 Adv module.
69/13
0/13