Baumfolder 714XA - Manual (Page 33)

TP10583 PAGE 30
H.) Loosen the 2 screws that are holding the deflector pusher in position
on the paper stop assembly with a 2.5 allen wrench.
I.) Move the deflector to the desired position to prevent the deflector
from rubbing the rolls. This should only be moved enough to not
allow the deflector to rub the rolls. This should be treated as a fine
adjustment and not adjust the deflector to much as the paper may be
able to enter the fold pan when the paper stop is in deflect, or if the
deflector is moved to close to the rolls, the paper will not properly
pass over the deflector and jam up in the fold rolls.See Figure #4 for
the dimension used in the factory setting and also the maximum and
minimum dimensions for this setting from lip of pan to outer edge of the deflector.
0.180”(4.58mm) FACTORY SETTING
0.173”(4.40mm) MINIMUM SETTING
0.185”(4.70mm) MAXIMUM SETTING
Figure #4
J.) Retighten screws retaining the deflector pusher screws on to paper
stop assembly. Be sure to not allow the deflector pusher to pivot as
you are tightening these screws up, as this may cause the deflector to
not be in the intended position.
K.) Recheck the position of the deflector as described by the dimension
called out in Step 1.I.
L.) Reinstall the fold pan into the folder and connect the plug.
M.) Turn the main power back on the machine.
N.) After power up, press the current fold icon in the upper left hand
corner of the production screen. Pick half fold P2 . Choose any paper
length. Next will send both fold pans to home position and then reset
their location according to the sheet length and type of fold currently
selected. "At Fold Position" message indicates the movement is done.
Note: The postion of the deflector will need to be adjusted in this
same manner any time the home position of the paper stop is
changed by making adjustments to the paper stop screws. If
this is not corrected each time these screws are adjusted,
serious damage to the folder or fold pans may occur!