Bang & Olufsen BeoSound Century - User Guide - Manual (Page 18)

> Using the tape recorder
18
Instant recording on tape
Press to make the tape recorder
ready for recording
then
Press again to start recording
Press to pause your recording
A pause of four seconds is inserted
on the tape
then
Press to resume recording
or
Press again to stop recording
completely
The two displays blink alternately to indicate a
recording of, for example, a CD track number
You can pause your recording any time
by pressing STOP. The tape recorder
automatically makes a pause of four
seconds on the tape.
Then press REC again to resume
recording; or press STOP once more to
turn off the tape recorder.
Note: To record a CD from the beginning – start
the CD player, then open the CD clamp by
pressing LOAD, and load the CD you wish to
record. While the CD clamp is still open, press REC,
REC: The clamp closes, recording starts, and the
CD starts playing from the first track.
Note: The REC button only becomes available if
there is a tape in the tape recorder – and provided
the tape is not record protected.
REC
REC
STOP
REC
STOP
Whenever the BeoSound Century is
playing, you can start recording directly
on the tape you have loaded. Just press
the REC button twice.
When you press REC the first time, the
tape recorder gets ready for recording.
The buttons necessary for recording
light up, and the display indicates that
the system is ready by, alternately,
displaying REC and then the number of
the radio program or CD track you are
listening to.
Press REC again, and recording starts
immediately.
> See the next few pages for further information
about recording and the automatic tape reverse
function.