Finding tracks or counter positions on the tape, Noise reduction – Bang & Olufsen BeoSound Century - User Guide User Manual

Page 17

Finding tracks or counter positions on the tape

While the tape recorder is playing, you
can make it find the next track simply
by pressing the step button, STEP

Or, you can make it play the current
track again by pressing

STEP once.

Press

STEP again if you want to hear

the previous track.

Pressing the step button several times
makes the tape recorder search
forwards or backwards for as many
tracks as you specify.

Noise reduction

You can also rewind or fast forward the
tape to a specific counter position.

To do so, you must first pause the tape
recorder by pressing STOP. While the
tape is paused, press

STEP or STEP

to rewind or fast forward the tape.

When you reach the position you want,
press STOP to pause the tape recorder;
or press TAPE to start playing the tape
directly.

Press to step to the next track on the
tape

Press to play the current track again

Press

STEP twice to play the

previous track

Press to pause the tape recorder

then

Rewinds the tape

Fast forwards the tape

Press to stop winding and resume
playing

STEP

STOP

TAPE

STEP

The display glows steadily when noise reduction is
ON, and blinks when it is OFF

Note: The noise reduction system is automatically
reset to ON during recording.

The noise reduction system is set to ON
from the factory. If you wish to change
this setup, you may do so by pressing
the MODE button.

The display then shows the current
noise reduction state: glowing steadily
for ON, blinking for OFF.

Press MODE again to change from ON
to OFF, or vice versa.

Press to see the current noise
reduction state

then

Press again to change from ON to
OFF, or vice versa

MODE