Bang & Olufsen BeoVision 5 - User Guide - Manual (Page 22)

22
Setting up BeoVision 5
We recommend that you follow the
procedure described below when you
set up your BeoVision 5:
– Unpack the BeoVision 5 and place
it as described and illustrated to
the right under Handling your
BeoVision 5;
– Consider the appropriate
surroundings for your BeoVision 5.
Guidelines are included to the
right;
– Connect the cables, additional
equipment, and speakers as
described on the following pages
and on the BeoVision 5 CD-rom.
For an overview of the connection
panels, refer to the chapter Socket
panels on page 28.
Handling your BeoVision 5
Due to the weight of BeoVision 5, any
moving/lifting should always be done by two
persons. BeoVision 5 is equipped with a
special handle for lifting it out of the packing.
After that the handle must be removed.
NOTE! BeoVision 5 is not designed to stand on its
own, it must be supported until mounted on the
chosen bracket or stand!
– Make sure that the BeoVision 5 is set up
and connected in accordance with this
Guide.
– The BeoVision 5 is developed for indoor use
in dry, domestic environments only. Use
BeoVision 5 within a temperature range of
10–40º C (50–105º F), and at an altitude of
no more than 1500 metres (5000 ft.).
– Do not attempt to open the BeoVision 5.
Leave such operations to qualified service
personnel.
Overview of socket and connection
panels
The illustration to the right shows the
placement of the various socket and
connection panels on the BeoVision 5:
1 Card slot – for future use
2 Speaker and digital input socket panel
3 AV and aerial socket panel
4 Card slot – for future use
5 Direct access socket panel
Before placing BeoVision 5 you must remove the
handle.
2
1
3
4
5