Balboa Water Group MLM990H User Guide - Manual (Page 6)

6
Programming
Set Menu
Home > Set >
> Spa Settings > .
In the “Set” menu (shown on the Home display screen),
you can preset (program) the equipment on your system,
and view diagnostic and software version information.
From within the “Spa Settings” menu, choose which
setting you’d like to change by using the arrow keys.
Set Temp
From within “Spa Settings”, highlight “Set Temp”,
,
or to set the temperature, .
(Note: The available range for adjustment of spa
temperature is 80°F - 104°F [26.0°C - 40.0°C], and may
be as low as 70°F in some cases). The last measured spa
temperature displayed is current only when the pump has
been running for at least 1 minute.
Note: To change the format from Fahrenheit to Celsius,
access the “User Settings” within the “Spa Settings”
menu. See User Settings under this section.
Mode or Heat Mode
Home > Set >
> Mode > .
This screen allows you to choose Standard, Economy, or
Sleep modes when using the heater. Select the mode,
then
.
“Standard Mode” maintains the desired temperature.
Note that the last measured spa temperature displayed is
current only when the pump has been running for at least
1 minute.
“Economy Mode” heats the spa to set temperature only
during filter cycles.
Turning on Jets 1 while in Economy mode puts the spa
in Standard-In-Economy mode, which operates the same
as Standard Mode, then reverts to Economy Mode
automatically after 1 hour. During this time, entering the
Mode Menu will revert to Economy Mode immediately.
“Sleep Mode” heats the spa to within 20°F (11°C) of the
set temperature only during filter cycles.
Filter Cycles
Home > Set >
> Filter Cycle > .
You are not required to set filter cycles; however, it is an
option available to you.
On all systems, the pump and the ozone generator will
run during filtration. At the start of each filter cycle, the
blower will run briefly on its highest speed to purge the
air channels. The lowest speed of any other pumps and
the Mister will also run briefly. On some circ systems,
Pump 1 may also run for the duration of the filter. There
are two filter cycles per day.
The start/end times of each cycle are programmable.
To program the cycles, the clock must be set. Under “Spa
Settings”, highlight “Filter Cycle” and Select (
).
Select Filter Cycle 1 or 2 by pressing or .
Arrow Down to the Start Time, then .
Select or to choose the “Start Time” hour.
Press to change minutes, then use the or to
select the minutes start time.
Arrow Right to change AM or PM on a 12 hour clock
(see “User Settings” if you don’t see AM or PM). Press
Select (
) to Save. Arrow Down to “Stop Time” and
repeat. Once finished, Arrow Left to Exit or resume to
set Filter Cycle 2.
If you would like to select continuous filtration, set the
Filter 1 start and end times to be the exact same time.
In this case, Filter 2 Start Time only controls when
the second purge happens. Filter 2 end time will
be unavailable.
Note: The menu panel requires that filters be set by
time of day, not duration. If you add a menu panel to an
existing system that uses a non-time-capable panel, this
system needs to be reconfigured by your installer.
Versions/Version Information
Home > Set >
> Versions > .
If you call technical support, you may be required
to provide system and panel information. Highlight
“Versions”,
to enter the “Version Info” display. Here
you will find the System and Panel version information.
Arrow Left (
) to exit.
MANUAL PANEL SET TINGS