Autocue QBox Installation Guide User Manual
Page 9
4. Configure QMaster:
Configure QBox
The first time you run QMaster, a QBox configuration wizard will guide you to configuring the
QBox within QMaster. Provide a name for the QBox ("QBox" will suffice), and the IP address of
the QBox.
If you need to configure the QBox manually: Go to Prompt->QBox Status panel. Right click in
the white box and select Add. Enter a name ("QBox" will suffice) and description for the QBox.
Then enter the IP address for the QBox. Leave all other default settings alone. If you see a
blue/green indicator next to the QBox, the QBox has been detected by QMaster. If the dot is
red, QMaster is not detecting the QBox on the network. Another possibility is that the QBox
firmware version does not match the version of QBox support you installed during QMaster
installation.
News Interface (Optional)
If configuring a News Interface, go to Tools->Options->News Interfaces.
Links to instructions fo
.
Other news interface documents can be found at this link:
Scroll Controls
For maximum flexibility, scroll controls can be connected to the PC and/or to the QBox.
The recommended option is to connect the controller to the QBox. In this scenario, should a
problem occur with the PC or network, you will be able to continue scrolling. This is not true if
the controller is connected to the PC. So it is a good idea to have at least one controller
connected to the QBox.
By default, you are allowed to connect one controller to the QBox and one to the PC. If you
plan to use more controllers, you will need to have purchased the multi-controller option.
Contact Autocue for more information.