Autocue QBox Installation Guide - Manual (Page 4)

3a. Version 1 QBox network configuration:
Press F8 to
bring up the QBox menu. Choose ‘Configure QBox’ by using the arrow keys and
pressing [ENTER].
Choose Network Configuration.
In the next screen, choose “Lan0” device.
In the General tab page, make sure Interface Enabled is checked. Make sure Activate at
system boot is checked. To check the box, use the tab key to highlight it, and then press
space key to check it.
Press tab until the General tab is highlighted. Press right arrow to reach the IPv4 Settings.
The recommended network setting to use is Manual configuration (Static IP address). You will